 |
- Install
the drain into the bottom of the basin and tighten retaining nut securely.
Finger tighten these parts ensuring that the drain does not turn. Do not
over tighten.
- Screw
the cap onto the drain. Optionally, connect a length of garden hose which extends to a floor drain.
- The humidifier
can be configured with either a right or left side air supply. Which is used will depend
upon the layout of your furnace.*
- Snap the
motor plate and inlet into the basin. Ensure that the basin tabs on these
parts fit into the corresponding slots in the basin. To remove the motor
plate and inlet, squeeze the lower tab with pliers and pull upwards.
|
