9. Startup, Maintenance and Shutdown

• Turn on the water supply to the humidifier (if it has not been previously done), turn on the electrical power and adjust the humidistat so that the humidifier starts. Adjust humidistat to the desired setting. Regularly change the setting in accordance with the outside temperature.
• At the end of the humidifying season, turn off the water, remove the disk wheel, agitate the water in a circular motion and drain the sediment and any water from the basin. Reposition the disk wheel and lid. Turn the humidistat off. Slide the damper to the closed position.
• Under normal conditions, minimal maintenance should be required. If you live in an area where the mineral content of the water is high (hard water), you may wish to drain the sediment as described above and periodically clean any minor sediment deposits from the basin and disk wheel. Use vinegar or any cleaner approved for plastic.
• After soaking in vinegar or cleaning solution, the disk wheel should be rinsed.
• Over time metal parts may discolour. This is a normal reaction and will not affect performance.
• For excessive mineral buildup, lower water level using ball valve and scoop minerals out. Hardened minerals will break off cleanly with minimal effort.

Disclaimer

Except as expressly stated in this manual, ATI Manufacturing Ltd., HighQProducts.com and MediaWave Communications Corp. make no representation or warranty with respect to the humidifier and disclaims all implied warranties including any warranty of merchantability or fitness for a particular purpose. In no event will ATI Manufacturing Inc., HighQProducts.com and MediaWave Communications Corp. be liable to any customer or user of the humidifier for any indirect, incidental, or consequential damages or loss of revenues or profits, whether the same are foreseeable or not, occasioned by any cause whatsoever including, but not limited to, the installation or operation of the humidifier.